What do the Janspeed exhausts look like?

The Janspeed exhaust systems for the Classic Range Rovers, Discovery Series 1 and Defenders 90/110 are all very similar in looks so we have pictured one for you below.

The system photographed below is for a 3.9 litre Range Rover Classic, although this will look like (and be the same specification as) most other Janspeed systems that we supply.

Above - One pair of Mild Steel Janspeed 4 branch exhaust manifolds, complete with Lambda sensor bosses (which can be blanked off if necessary)

This center section is supplied as two parts, both in 304 grade Stainless Steel. The Y-piece has two sleeve joints to go directly over the manifolds and then goes to a 3 bolt flange. This Y-piece is the non-CAT version. The second part pictured is the center silencer box again from the highest grade 304 stainless steel, with hanger ready to bolt directly as replacement of your standard system.

The last section of this system is the rear tail pipe, preformed to avoid the rear axle and again with a sleeve joint to connect to the center silencer box. Made from 304 grade stainless steel and includes an integral silencer.